Since so many companies are introducing cam to cam reverse osmosis systems, it’s hard to know who to trust. We already had problems with reverse osmosis tanks, even after the Oto-Mangiulo recall, so how safe should we be?
These products are said to be environmentally friendly
But some say they use more water than traditional reverse osmosis systems. They are said to be more efficient at removing contaminants from water, but they are also more expensive.
They have been tied to an increase in asthma and allergies among children, but their use has been tied to reduced childhood diarrhea.
All of these negative claims aside, a few positive attributes about the technology still remain. It’s designed to remove smaller sized particles, therefore the amount of water it needs to take in for filtration is less.
When the negative side effects of reverse osmosis systems were revealed, it wasn’t long before companies jumped on the bandwagon and began introducing cam to cam systems to counteract the problem.
By adding several additional filters, it would absorb more contaminants than a standard system would. Now, though, there are more people coming forward with stories of what happened when they bought these types of systems because they haven’t lived up to their hype.
The primary complaint is that contaminants end up getting back into the system after being filtered. This is true and can happen if you’re not careful.
If you don’t keep an eye on your water while it’s sitting in the tank
You could end up absorbing many small particles into the tap water. And it’s possible that the contaminants would eventually be re-released into the system unless you unplug the whole thing and remove the filter from the entire system.
Unfortunately, removing the first stage of reverse osmosis systems makes them unreliable for households and businesses. You can plug the whole thing back in, but the contaminants may never get absorbed by the tank again.
The same applies to the design of cam to cam systems. The filter needs to be emptied at least once a week, and you can’t run the whole system if you don’t do it. Therefore, the only way to really get good quality water is to remove all of the filters in the home or business.
Many people have had health problems with reverse osmosis systems, and that’s a reality, no matter what claims the companies make. But it’s important to remember that the system works, even if it doesn’t work as efficiently as it could.
There are better ways to purify water with cam to cam systems
The entire system doesn’t need to be unplugged, and the use of solid media is often preferred. No solid media would include submicron filters, because they only work to get out large particulates.
With reverse osmosis systems, there is always the chance that a large particle may be released into the water. Because the system was designed to stop that from happening, manufacturers will want to make sure that solid media is used instead.
Using solid media removes the contaminants from the water, but that doesn’t mean the reverse osmosis system has to be plugged. You can use a series of filters to remove them before you even get to the first stage of the system.
Though it sounds complicated, removing the first stage of reverse osmosis systems is simple. Do it for yourself, and avoid the dangers of reverse osmosis tanks.